I don't know what this mouse sensitivity has been all about but in the latest patch I can now use teamviewer remotely and interact with the game. Sweet!

On my 29" iMac (resolution 2560 * 1440) I get the same list of resolutions in Cap Lab

I thought it was creating the list of resolutions dynamically, but its just a static list it seems.
Even though my iMac display would support it, again the 1600 resolution is disabled, but the rest work great.

In windowed mode its a little temperamental, but you can just run the VM as a window, and fullscreen Cap Lab within that

[quote="David"]Will improve this in the upcoming patch v2.3.05.[/quote]

I just noticed 2.3.05 has been released. The new mouse settings seems much better, thanks!

[quote]By the way, which screen resolution modes were you able to get CapLab to run in VMWare Fusion on Mac?[/quote]

My 11" Macbook air has native res of 1366 * 768, so My VM uses this too at fullscreen

Cap Lab offers me these resolutions

1024*768
1366*768
1600*900 [DISABLED]
1280*1024
1920*1080

All 4 resolutions work well in fullscreen mode, and interestingly this includes the 1920*1080 which I assume VMware is scaling to fit my lesser display

I just rememebred too, I recently upgraded from VMWare Fusion 5 to v6.
So this may be one of the reasons its working a lot better than before

Will improve this in the upcoming patch v2.3.05.

By the way, which screen resolution modes were you able to get CapLab to run in VMWare Fusion on Mac?

The current beta release now works well in VMWare Fusion (on Mac)
I've had problems with earlier releases due to screen resolutions etc, but full screen is working great now.

One minor issue remaining..

The mouse sensitivity is too low, even when the slider is set at maximum. Im not saying the mouse lags, it just doesnt move quickly enough compared to physical mouse.

Could we increase to range of the sensitivity slider please? I think I would need to set it to an extra 60%-70% on top of the current slider value, for it to be usable.

This would seem a simple way to fix it, and then everyone on Mac can start enjoying Cap Labs too

Thanks